Beger SuperDeck

1. Surface preparation 1.1 If the wood has been painted before and the film is peeling, or it is old wood that has never been painted, sand it back to the bare wood. For new wood, sand off excess wood fibers. Then clean the surface so it is free of grease, dust, oil and foreign matter. 1.2 If the wood floor stain film is in good condition, scuff the film with No. 320 sandpaper and then clean the surface so it is free of grease, dust, oil and foreign matter. 1.3 If the wood has resin, wipe off the resin with Thinner M-77. 1.4 For hardwood, first sand with No. 80-100 sandpaper to open the grain so Beger Super Deck wood floor stain can soak in and fully protect the wood. 1.5 Fill holes and nail heads with Beger Wood Filler, leave for 30 minutes, then sand and clean

2. Primer: can be applied without a primer

3. Topcoat: 3.1 Apply along the length of the wood, not across the grain. 3.2 For exterior wood floors, apply 2-3 coats of Beger SuperDeck wood floor stain for good protection, letting each coat dry for 3-5 hours. In very hot weather, thin with Beger Thinner M-1199 at a ratio of 3:1