Beger DeckStain

1. Surface preparation 1.1 If the wood has been painted before and the film is peeling, or it is old wood that has never been painted, sand it back to the bare wood. For new wood, sand off excess wood fibers. Then clean the surface so it is free of grease, dust, oil and foreign matter. 1.2 If the wood floor stain film is in good condition, scuff the film with No. 320 sandpaper and then clean the surface so it is free of grease, dust, oil and foreign matter. 1.3 If the wood has resin, wipe off the resin with Thinner M-77. 1.4 Fill holes and nail heads with Beger Wood Filler, leave for 30 minutes, then sand and clean

2. Primer: can be applied without a primer

3. Topcoat: 3.1 Stir the paint thoroughly until uniform before use, and stir regularly during application, from the bottom of the container upward. 3.2 It can be applied without thinner, but in very hot weather thin with no more than 5-10% Beger Thinner M-1199. 3.3 After dipping, wipe off excess paint before applying; do not apply with an overloaded brush. 3.4 Apply along the wood grain, brushing back and forth so the stain penetrates the wood better. 3.5 For exterior wood floors, apply 3 coats; for interior wood floors, usually only 2 coats are needed. Let each coat dry for 8-10 hours, and coat all sides of the wood for the best protection