Beger Aqua WoodStain

1. Surface preparation 1.1 If the wood has been painted before and the film is peeling, or it is old wood that has never been painted, sand it back to the bare wood. For new wood, sand off excess wood fibers. Then clean the surface so it is free of grease, dust, oil and foreign matter. 1.2 If the wood floor stain film is in good condition, scuff the film with No. 320 sandpaper and then clean the surface so it is free of grease, dust, oil and foreign matter. 1.3 If the wood has resin, wipe off the resin with Thinner M-77. 1.4 Fill holes and nail heads with Beger Wood Filler, leave for 30 minutes, then sand and clean

2. Primer: can be applied without a primer

3. Topcoat: 3.1 Stir the paint well before and regularly during application for the best results, and use a soft-bristle brush. 3.2 It can be applied without water, but for smoother brushing you can add 5-10% clean water to the first coat; no water is needed for later coats. 3.3 Apply at least 2-3 coats for the best film performance, letting each coat dry for at least 1-2 hours before the next. Sand along the length of the wood with No. 280-320 wet sandpaper until no raised fibers remain, to improve adhesion. After the final coat, leave for about 24 hours before using the area. 3.4 Do not apply outdoors in strong direct sunlight