Beger Aqua Sanding Sealer AP-500

1. Surface preparation 1.1 If the wood has been painted before and the film is peeling, or it is old wood that has never been painted, sand it back to the bare wood. For new wood, sand off excess wood fibers. Then clean the surface so it is free of grease, dust, oil and foreign matter. 1.2 If the wood has resin, wipe off the resin with Thinner M-77

2. Primer: 2.1 Apply 1 coat of Beger Sanding Sealer water-based AP-500 to block wood resin and fill the wood grain, and let it dry for about 1 hour. 2.2 Fill holes or nail heads with Beger Wood Filler, leave for 30 minutes, then sand and clean. To match the filler shade to the wood, fill after priming, because wood naturally darkens once primed. 2.3 Finish with 3-4 coats of Beger AquaPU or Beger AquaLac water-based products, letting each dry for 1-2 hours; this helps save on topcoat