Beger Clear Gloss Lacquer L-5000

Step 1 Surface preparation: Previously painted / old wood – if the wood has been painted before, has a peeling film or is old wood that has never been painted, sand it back to the bare wood and clean the surface so it is free of grease, dust, oil and foreign matter. If the lacquer film is in good condition, scuff the film with No. 320 sandpaper and then clean the surface so it is free of grease, dust, oil and foreign matter. If the wood has resin, wipe off the resin with Thinner M-77, and fill holes or nail heads with Beger Wood Filler, leave for 30 minutes, then sand and clean. New wood – sand off excess wood fibers, fill any holes or nail heads, and clean the surface so it is free of grease, dust, oil and foreign matter

Step 2 Primer: spray or brush 1-2 coats of Beger Sanding Sealer L-5555 grain-filling primer, allowing about 30 minutes to dry between coats

Step 3 Topcoat: spray or brush 2-3 coats of Beger Lacquer L-5000, letting each coat dry for about 30 minutes before the next