Step 1
How to use • Equipment: brush and roller; clean tools with clean water after use • Thinning: clean water or tap water • Conditions during application: the concrete surface should not have a moisture content above 14% • Mixing before use: add 15-20% clean water by volume. Painting system • Surface preparation: New plaster – let the plaster dry completely for at least 1 month, or until its moisture content is below 14%. Old plaster – scrub off deteriorated old paint; areas with mould or moss must be scrubbed with Beger MouldFree M-001. Tip: clean all surfaces and let them dry completely, free of dust, mould, moss, cement residue, oil stains and other dirt. Repair cracks smaller than 1 mm with Beger Acrylic Filler (F-200), or use Beger Acrylic Sealant (F-001) for cracks from 1 mm to 1 cm. Good surface preparation with no dusty or loose areas gives Beger Super Hi-Shield the best adhesion • Paint system for new plaster: * Primer: 1 coat of Beger Super Hi-Shield alkali-resistant primer for new plaster, exterior and interior, S-8888 * Topcoat: 2 coats of Beger Super Hi-Shield matte for interior use. For old plaster: * Primer: 1 coat of Beger Clear Contact Primer B-1500 * Topcoat: 2 coats of Beger Super Hi-Shield matte for interior use
